What should be paid attention to during the use of flame retardant conveyor belt

The flame-retardant conveyor belt is different from other layered nylon canvas conveyor belts and steel cord conveyor belts.

So when the flame-retardant conveyor belt is scratched, damaged, or jointed, be cautious and never use iron wire or belt buckles to simply repair the trouble. Because the above methods are used to repair the whole core flame-retardant conveyor belt, it is very easy to induce secondary damage to the whole core flame-retardant conveyor belt, or even longitudinal tear instead.

Flame-retardant conveyor belt is a quick way to repair scratches, breakages, etc.

The effective way to replace the flame retardant conveyor belt with scratches, breakages and other damages is to use RAMIMTECH cold vulcanization bonding to repair.

The specific operation steps are as follows:

Polish the surface of the conveyor belt, and the depth of polishing must be higher than the height of the repair strip.

Clean and polish the surface of the conveyor belt to ensure that there is no dirt and debris on the polished surface of the conveyor belt.

Warm reminder: If it feels like dry but not dry, you can touch the bonding surface with the back of your finger. If it feels like sticky or not dry, you can start the bonding repair.

4. Use compaction rollers to roll and bond the RIT repair strip from one side to the other, which can effectively prevent air from entering and improve the bonding strength of the repaired part.

5. Apply adhesive once along the edge seam of the bonding surface to block the small seams.

Note: If the conveyor belt is cut through, the same method can be used to paste the RIT repair strips on the upper and lower sides.

For flame-retardant conveyor belt thermal vulcanization joints, it is necessary to choose a regular unit and use better materials for bonding. Inmate flame-retardant conveyor belt thermal vulcanization joint material is a good choice, using regular flame-retardant conveyor belt thermal vulcanization joints The material can effectively prevent the joints of the conveyor belt from pulling.